AVP Shuriken - Rev 3

spgfx

Hunter
I have had nothing but trouble with my current Shuriken mold. I have not been able to get a bubble free cast of the single piece setup and shipping is a bitch.

Solution: make a multi piece mold. I redesigned things so all the legs are the same and snap into the main body. There is a separate top piece that will cover the top section when the legs mount.

Here is where I'm at so far.

The legs are all cut and glued ready for rough sanding. I beefed up the main body to add some strength and get a better match to the main body thickness.

image.jpeg image.jpeg

Here is the leg mounting before and after the top section is installed.
image.jpeg image.jpeg image.jpeg

The main body and top piece are all glued and ready for rough sanding.

image.jpeg image.jpeg image.jpeg

image.jpeg


image.jpeg


image.jpeg


image.jpeg


image.jpeg


image.jpeg


image.jpeg


image.jpeg
 
Top