New project finished!

Destroyer

Hunter
Thigh armor for holding the Predator's throwing disc?

Edit: Oops, DangerDavey beat me to it. I opt for non-magnetised! :)
 

roundhammer

Hunter
Oooh! A magnetized P2 disc holder??

~DD
DING DING DING! WE HAVE A WINNER!

d2az6.jpg


d1sw2.jpg


The magnets are high-strength neodymium (rare earth) magnets. I can flip it face down, and the disc doesn't move one bit. The disc itself attaches to the magnets via nail heads imbedded in the bottom.

The body was carved out of pine that was glued together from 5 sheets of half inch thick boards, the circles were cut into the face using a router. The inner most circle is around 1 inch deep. The body was then covered in a thin skin of super sculpey, small details added and cooked. The inside of the face was covered with several coats of gesso and the very inner circle was detailed using an experiment of pressing details into a circular piece of play-doh. Once it was dry, it was glued in place and the entire piece painted. It's very light weight. I got the idea for this after seeing a picture of a similar device sculpted onto a Predator model...

inspirationfc1.jpg
 
Top